APV standard 'P' type plate material is AISI 316 stainless steel and interlocking
soldered with copper. Braze heat exchangers at 450 psig/31 bar operating pressure
they can operate at a maximum temperature of 437°F/225°C. P series is usually custom
While minimizing heat losses thanks to isolation kits, with Y-filter
exchanger is preserved.
In a basic system design, the primary circuit heat source such as a hot water boiler
while the secondary circuit may be melted snow water or refrigerants.
Instant hot water in plumbing can be achieved with the use of appropriate controls.
Due to the low internal volume in the Braze heat exchanger, instant hot water can be produced and
so they can make the hot water tanks disappear.
Particulate matter in brazed plate heat exchangers due to turbulent flow
it is difficult to get dirty. Heat exchanger plates 1.5 times more than normal flow
by backwashing with phosphoric acid or citric acid solution in the flow
can be cleaned. Braze heat exchangers are available for bulky tubular, helical, coaxial and other
Braze plates replace less efficient heat exchangers.
designers don't just think about the exterior, but also
It allows making smaller sizes that push the limits.
APV ParaBrazed plate heat exchangers do not have gaskets, studs or slides. separate plates
are permanently brazed together in a vacuum furnace. Thus compact and durable gasketless heat exchangers
gets produced.
In typical applications such as low-cost and low-maintenance district heating, such heat exchangers are highly effective.